NaceCare PSP200A Canister C...
$42.99
Product details
Part 236025 is the complete cord assembly for the NaceCare PSP200A canister vacuum, and the same part is used on the PSP380 and on the PCP180 James model, so it is stocked once and fits all three.
A canister that gets rolled across a job site, run over by a mop bucket, or dragged by its own lead between rooms puts real wear into the cord long before the motor shows any sign of age. The failure pattern is familiar: the jacket splits somewhere along its length, the machine cuts out when the cord is stepped on or pulled taut, or the plug itself feels warm after a few minutes of use. Any of those is worth acting on immediately rather than working around, since a compromised cord is an electrical hazard on a machine professional crews handle for hours at a stretch.
The mains lead on a canister like this typically anchors into the housing through a strain relief grommet rather than a hard-wired connection, so the swap is done without needing to open the motor housing itself. Keep the replacement cord's connector oriented the same way the old one was before it is fully seated, since a twisted connection can pinch the jacket against the housing over time.
Fitting the new assembly is a straightforward swap at the point where the old cord enters the machine body; disconnect the unit from power first and note how the old cord was routed before removing it.
- Part: 236025, complete cord assembly
- Fits: NaceCare PSP200A, PSP380, PCP180 James canister vacuums
- Replace when: the jacket is split, the machine cuts out under strain on the cord, or the plug runs warm
- Install: disconnect from power first and note the original cord routing before removing it