SEBO Back Cover for the TS-Neck — FELIX, ET-1, ET-2 and DISCO, Gray Black

Behind the TS-neck joint sits a molded panel that caps the back of the head. Part 2947GS is that panel in gray black, shaped to the housing contour and drilled for the original screws, so the head goes back together without packing or shimming anything into place.

SEBO's power head diagram numbers the cover 115, and the FELIX sheet uses the same number, immediately after the swivel neck wiring at 114 and just before the metal segment set at 116. Panels crack where they get gripped during a wand change, or when the head is tipped hard against a stair nose. Once broken, the opening lets dust reach the neck hardware and the joint loses some of its stiffness, so the head feels less planted underfoot. Replacing the cover is a screwdriver job with the head on the bench, and it is the right moment to look at the segments and slide inside the same joint.

• Part number: 2947GS, TS-neck back cover
• Color: gray black
• Fits: ET-1 and ET-2 power heads, switched and unswitched, and the DISCO floor polisher
• Also listed for: FELIX Premium, FELIX 2 Premium, C3.1, AIRBELT D4 PREMIUM, AIRBELT E3 Premium and AIRBELT K3 PREMIUM
• Diagram position: 115 on the power head and FELIX sheets
• Other finish: light gray panel 2947HG
• Related part numbers: 0876ER swivel neck wiring at 114, 2950ER segment set at 116, 2945GS slide at 119
• Fitting tip: photograph the screw layout before the old panel comes off

A genuine SEBO TS-neck cover keeps the dust out of the joint it protects, which is the whole reason to fit the correct moulding rather than tape over a split. Factory SEBO part supplied by an authorized dealer, shipping in 2–5 business days.