SEBO Pin with Screw and Was...
$6.99
Product details
Three pieces travel under one catalogue number: the pin itself, the screw that retains it and the washer that goes between screw head and moulding. SEBO lists the set for the C1.1, C2.1 and C3.1 canisters.
The pin is an axis. A moving component turns on it, and the screw with its washer is what stops that pin walking out of its bore under the vibration of a running machine — which, given enough hours, is exactly what an unretained pin does. That is why the three are sold as a set: fitting a fresh pin under a screw whose thread has already given up is a repair with a short life ahead of it.
Two fitting notes decide whether the joint lasts. Put the washer back where it belongs — without it, the screw head presses straight into the plastic and cuts its own recess, which is how a joint that was merely slack becomes one that will not hold at all. And tighten to snug rather than hard: the thread is going into a moulded boss, not steel, and a single turn past snug strips it, turning a small hardware order into a housing repair.
What sends people looking is play at the pin. A component that rocks where it should be firm, one sitting slightly off square, or one that clicks once each time it moves through its travel. Related C-series internals carrying the same listed fitment are the rod 6022 and the springs 6023 and 6045, worth inspecting while the assembly is open. Shoppers reach this listing searching for a SEBO pin screw and washer set, C3.1 pivot pin hardware, or genuine SEBO fastener 6027ER.
- Fitment: SEBO C1.1, C2.1 and C3.1 canister vacuums
- Pack: pin, retaining screw and washer
- Part number: 6027ER
- Change it when: the component it carries has developed play, sits out of line, or clicks in use
- Nearby C-series numbers: 6022 rod, 6023 spring, 6045 spring
Genuine SEBO hardware, dispatched in 2–5 business days.