Oreck XL21-600ECC Main Bump...
$9.99
Product details
The main bumper on an Oreck XL21-600ECC is the gray trim strip that rides along the leading edge of the machine, standing between the housing and every baseboard, chair leg, and door frame the nozzle runs into. Order it as part 430001003.
On a machine run daily, that job eventually wears the strip out. It cracks at a stress point, a section works loose or breaks away, and part of the strip ends up hanging or missing outright. Once it is gone, the housing underneath starts absorbing those same knocks directly, picking up scuffs and then chips, while nearby furniture starts collecting marks from a machine that used to bounce off harmlessly.
A bumper only works while it can still give a little: it takes an impact instead of passing it straight into the housing behind it. Once the strip splits or a section works loose, it stops doing that job even while the remaining piece still clings on, so a bumper that rattles when tapped has often already stopped protecting anything. The replacement takes the place of the original strip; work it into position progressively along its length rather than forcing the whole run at once, and check it sits evenly from end to end before the machine goes back into service.
- Part: 430001003
- Color: gray
- Fits: Oreck XL21-600ECC upright
- Function: front impact bumper
Confirm your model number is the XL21-600ECC before ordering, since this gray bumper is listed for the XL21-600ECC specifically, and a strip shaped for a different machine will not seat flush along its full length.